Stalagmite®      Pouring Standard Impressions (using the Pouring Jig)

 Condensed instructions:
                                                   
1. Determine size and if upper or lower,            2. Use an Impression Index-Plate to create
then select correct Pin-Locator.                        a negative plaster index for the impression.

             
3. Position impression relative              4. Replace Pin-Locator with correct RTP_Base. Make
to the Pin-Locator.                              sure yellow Swing-Arm contacts the green Stand.

                    
5. Pour impression and trim excess                  6. Remove impression and trim model.
stone before it sets.                                        Last step... Admire your work.

Home     Page > 1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26