Pouring
Arch Impressions:
After the stone has initially set, use an instrument to remove the excess stone. Be careful not to pull the stone away from the base while removing it. Rather, you should trim it in such a way that causes a little pressure in the direction of the base. The same applies to the stone being trimmed inside the Arch. You can use a damp finger to add the final touches.
Be
sure to fill voids or areas requiring additional stone before starting
the trim phase. It may be necessary to lift up on the RTP_Base to add additional stone. If you do this, be sure to dress up
the stone by tapping on the side of the RTP_Base while the pins are
pointing up. This procedure will resettle the stone around the pins (just as you did
when starting the pour). You can also tap on the
impression to settle any additional stone that was added.
Home Page > 1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26