Preparing
the
impression for pouring:
Caution:
Do not over tighten the Swivel Table Knob,
it only takes about one quarter turn in the Clock-Wise (CW) direction to lock it sufficiently.
One quarter to one half turn in the Counter-Clock-Wise (CCW) direction
is sufficient to loosen. It takes several turns to unscrew the Swivel
Table Knob all the way out. If this happens you will need to
return it to us for repair. Once the cams inside move, it has to
be disassembled and the Swivel Table Knob reinserted. The six Torx
screws must be installed with a torque wrench to insure longevity.
We can overnight you a loner Swivel Table Assembly
until yours has been repaired. The whole assembly is removed
by loosening the small Allen Screw on the Jack Stand just below the red
Jack Stand Nut. When re-installing the Swivel Table Assembly, do not
over tighten the Allen Set Screw or you will strip the plastic
threads in the Jack Stand. Just screw it in until it stops.Home Page > 1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26