Sizing:
1. Determine if the impression is upper or lower. If upper, select an Upper
Pin-Locator (as shown above).
2. Determine which size Pin-Locator matches
the tooth location best. It is suggested
that you start with the medium (green) size because
most impressions will fall into
the medium category.
Caution:
As mentioned earlier, at the bottom of page-2 in the Introduction, not
all impressions can be poured with the Stalagmite System. It is best to
check the impression first with the Pin-Locators, so you do not waste time making a
plaster index that you cannot use. Also, if the impression is not a
medium, it is a good idea to mark the size on the impression tray so you
will know what size Pin-Locator you will need when starting the set up
procedure on the Pouring Jig .
Home Page > 1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26