Stalagmite      Pouring Standard Impressions (using the Pouring Jig)

Preparing the impression for pouring:

                 

The Pouring Jig Swivel Table has two holes to receive the two pins on the bottom of the Impression Index-Plate (red arrows). Place the Impression Index-Plate onto the Swivel Table making sure that the two pins are engaged in the holes. It helps at this point to center the Jack Stand Sliding Table inside the smaller of two engraved circles on the Main Top Plate of the Pouring Jig.

                      

Attach the correct Pin-Locator to the Pouring Jig Swing-Arm Assembly. A Medium (green) Upper Pin-Locator is shown above.

Home     Page > 1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26