Condensed instructions:
  

1. Determine if upper or lower, then                2. Attach Pin-Locator to the Opposing_Base
select correct Pin-Locator.                              (impression may need trimming).
                                          
3. Pour opposing side of impression and          4. Exchange Pin-Locator for RTP Base
trim excess stone before it sets.                       and add die pins where needed.

                                
5. Pour Die side of impression and                  6. Remove impression and trim models.
trim excess stone before it sets.                       Last step...  Admire your work.

Home          Page > 1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23