Pouring Triple Tray Impressions
Stalagmite
          (using the Articulated Triple Tray System)

Test before pouring die side of the impression:

                        

Lower the RTP Base into position until the hinge-stop-rods make contact. You may need to trim the impression before the hinge-stop-rods will come together.

 

                        


Double check die pin locations from all angles to make sure there is no contact between the RTP Base and the impression. If everything checks out, then you are ready to pour the die side of the impression.

Home          Page > 1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23