Stalagmite® (using the Articulated Triple Tray System)
Repositioning
the opposing model:
There is a pilot hole under each of the six retention pins in the Opposing_Base. Insert a 3/32" or 2.38mm drill into a hand-piece and drill into the pilot hole at least 2 mm. This will sever the retention pins and allow the stone model to be removed from the Opposing_Base.
Tapping on each end of the lower Opposing_
Base in the location marked by the red
arrows, will dislodge the stone
model.
The inside walls of the Opposing_Base are
tapered to
allow the stone model to be
easily removed once the retention
pins
are
severed.
Home
Page > 1
2 3
4 5
6 7
8 9
10 11
12 13
14 15
16 17
18 19
20
21
22 23