Stalagmite®    Pouring Triple Tray Impressions (using the Pouring Jig)

 Condensed instructions:
              
 1. Determine size and if upper or lower,             2. Setup Pouring Jig for Triple Tray
 then select correct Pin-Locator.                          impression (see page 5 of this section).

              
 3. Pour Opposing_Base and ensure                   4. Exchange Pin-Locator with RTP_Base
 proper alignment with Pin-Locator.                   so you can pour die side of impression.

                
 5. Pour die side of impression and trim              6. Remove impression and trim models.
 excess stone before it sets.                                Last step... Admire your work.

Home          Page > 1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21