Preparing to pour "Arch" Triple Tray Impressions:

To reiterate; when pouring
Triple-Tray impressions using the
Pouring Jig, you must add the Stand Extension to the top of the Pouring Jig Stand to compensate for the added
thickness of the Opposing_Base.

The Arch Opposing_Base serves as an upper or lower. Even though the impression is a large, you could use a smaller Opposing_Base in situations such as a Class-3 bite.


Remove the Opposing_Base from the Swing-Arm Mounting Plate and replace it with the
proper Pin-Locator as shown above.

Test the height of the Swivel Table and check for possible interferences from the impression before pouring
the opposing side of the impression.






To reiterate, do not forget to add the Stand Extension to the top of the Pouring Jig Stand when pouring Triple-Tray impressions.

Home          Page > 1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21