Preparing
to pour "Quadrant" Triple Tray Impressions:
Configure the Pouring Jig as per page 5 of this section (be sure to add the Stand Extension, center the Jack Stand,
and level and align Swivel Table etc.).Once you determine the correct size and type of Pin-Locator that best fits the impression, snap it onto the Pouring Jig Mounting-Plate.
Attach the Opposing_Base to the Opposing Index-Plate as per instructions on pages 2 and 3 of this section.
Adjust the height of the Swivel Table and test the position of the impression. It may need some trimming.
The height of the Swivel Table is not critical at this point (just a close approximation).
Outside or buccal view...
Home Page > 1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21