Pouring
"Arch" Triple Tray Impressions:
Remove the impression and attached Opposing_Base from the Index-Plate and pour die side of the impression. When pouring the impression, be careful not to dislodge the impression from the stone and Opposing_Base.
Reattach the Opposing_Base and Impression to the Pouring Jig Index-Plate.
Tease some stone around pins and surface of the RTP_Base. Tap lightly on the side of the base to
settle the stone.
Add a little extra stone to the impression and base
before rotating over into final position.
The RTP_Base is lowered into position
by applying downward pressure on
the yellow Swing- Arm while lightly tapping the RTP_Base on the side
with a spatula or other instrument.
This will settle the RTP_Base into position until the yellow Swing- Arm "stops" make contact with the
green Swing-Arm Stand (see red
arrow).
Caution:
Do not push down on the Mounting-Plate. If you do, it will bend down and
spring back up when pressure is released. This will take the stone out of compression and pull
it away from the RTP_Base while increasing the possibility for other
voids. Put downward pressure on the yellow Swing-Arm "only."
Home
Page > 1
2 3
4 5
6 7
8 9
10 11
12
13 14
15
16 17
18
19 20
21