Stalagmite®              ATT System (uses Removable Tapered Pins)


Quadrant parts for the Articulated Triple Tray Dental
      Model System:
   
The die pin holes are precision tapered to receive a Removable Tapered Pin (hence the RTP designation). The index pins prevent the die from rotating or twisting and are strategically located to prevent putting a die into the wrong location. (However, this does not prevent you from putting a die into the same location on the wrong base.)

The notches at both ends of the Bases will receive a plastic stop rod (3/16" or 4.75mm). A thin membrane must first be removed at the end of each notch.

Opposing_Base retention pins can be drilled out from the bottom so the opposing model can be removed and relocated. This is handy when a bite relationship needs to be corrected.

Home          Page > 1 2 3 4